|Tax Status:||Tax Paid|
Camaret Sur Mer Brittany France|
MCA coded cat. 2
Vetus 30Hp 4 cly.
Sails:- Main (3 slab reefs), Genoa (Alado roller furling), Asymetric spinnaker with sock, storm jib.
Galley:- 2 burner gas stove, Fridge, Double sink with hot and cold pressurised water system, 400lt. water in two tanks.
Accommodation:- 6 berths (re upholstered 2019), double aft cabin, two saloon berths with lee cloths, fore cabin V berths with infil.
Toilet with holding tank, Shower.
Electric bilge pump with alarm plus manual bilge pump. Electri windlass (chain and rope), 30m 8mm chain spliced to 50m rope, Bruce anchor.
GPS plotter, radar, wind, depth, speed, electronic and magnetic compasses, tiller pilot.
Dinghy (new 2021), Liferaft (new 2020).
|Vessel type:||Steel Cruising Yacht|
|Builder:||Van de Stadt|
|Make:||Van de Stadt|
|No. of engines:||1|
|Drive type:||Shaft drive|
|Length over all:||10.37m|
|Hull type:||Fin Keel|
|Keel type:||Fin Keel|
|Dry Weight:||7 tons|
|Fuel capacity:||150 Litres|
|Water capacity:||200 Litres|
Main saloon comprising Nav station, galley, seating and table. The two seats down either side become full width single berths (with lee cloths). The fore cabin has two berths as a V berth with an infill to form a double. Hanging locker either side. The aft cabin is a double berth. There is a separate toilet compartment with a shower.
30 hp Vetus 4 cld. The Heat exchanger was replaced in 2019. There is easy access all round. General maintenance (filters, belt, impeller, oil and coolant) with just the top and front panels removed. Both the sides panels can also be removed and the rear of the engine (gearbox and couplings) is accessed via a panel in the aft cabin.
Note: Indicated location is approximate general area only.